smd.lotharek.pl - Professional electronics` assembly on a production line with the capacity of up to 18000 components per hour, based on Neoden / Yamaha equipment                                                                                                                                  

smd.lotharek.pl - Professional electronics` assembly on a production line with the capacity of up to 18000 components per hour, based on Neoden / Yamaha equipment                                                                                                                                  

Currency

Shop categories

REV C - HXC SD Floppy Drive Emulators

REV F - HXC SD Floppy Drive Emulators

MAX HXC SD Floppy Drive Emulators

SLIM - HXC SD Floppy Drive Emulators

USB - HXC USB Drive Emulators

Amiga

FPGA Computers

ATARI 16bit

Atari 8bit upgrades

Atari 8bit mass storage devices

Atari 8bit accessories

ZX Spectrum / Timex / Compatible

Commodore

Memory Cards

Cables / Adapters

Audio/Video devices

Power supplies

In development

Services

Discontinued

REFURBISHED

    Special offer

    Wireless USB mouse adapter

    Wireless USB mouse adapter

    Discontinued

    Like Ask Tell

     

    USB wireless mouse adapter for AMIGA/ATARI STe

    Based on open source Smally Mouse ( https://github.com/simoninns/SmallyMouse2)

     

    Device may work in two modes:

    • AMIGA ( switch up )
    • ATARI ST ( switch down)

     

    DISCLAIMER:

    • device may not work with wired mouses, that needs to much current, so preferably use wireless ones

     

     

     

     

    Product gallery

     

     

    UPLOADING FIRMWARE:

    • get usb A-A cable
    • Download driver pack ( in win10 i had to disable driver signature enforcement) 
    • Set 2 dip switches to ON posistion
    • Connect to PC and move dip switch 1 to OFF position; windows will detect hardware
    • install driver (accept RED WARNING BOX)
    • You shall have sth like this:

     

     

     

     

    • Download and install  software FLIP
    • in FLIP:
      • DEVICE -> SELECT -> AT90USB1287
      • SETTINGS -> COMMUNICATION --> USB --> OPEN
      • You shall have sth like below:

     

     

     

     

    • FILE --> LOAD  SMALLY MOUSE FIRMWARE  and press button RUN 
    • move second  dip switches to off so BOTH ARE OFF and disconnect
    • READY

     

    PS. ORDER OF STEPS IS IMPORTANT